锋范油箱盖怎么开

Hello everyone, today I am here to share some knowledge about how to open the fuel tank cover of the Fengfan car, and analyze the problem of where and how to open the fuel tank cover switch of the Fengfan car. If you all understand it, you can ignore it. If you are not clear, you can read this article, I believe it can solve your problem to a great extent. Let's take a look together!

How to Open the Classic Fuel Tank Cover of Fengfan

The classic Fengfan radiator cap can be opened. The Fengfan radiator is located between the engine front, the condenser, and the fan. The vehicle radiator generally refers to the radiator, and the water inlet of the radiator is located on the upper part of the radiator, while the drain valve is located at the bottom of the radiator. The coolant is added, and tap water can be added in special cases.

The method for replacing the Honda Fengfan coolant is as follows:

1. First, park the vehicle for a while to prevent burns from the coolant. The drain screw of the coolant is located at the bottom of the radiator. Find it and loosen it. The coolant can be seen flowing out from the drain port.

2. Shift the vehicle into neutral and pour clean water into the coolant reservoir. The principle is to flush the original coolant with clean water until the discharged water has no color. At this time, the old coolant is basically cleaned.

3. After draining the water, install the drain valve and turn off the engine. Add new coolant to the filling port, and the liquid level should be between MAX and MIN. If you accidentally add a little more, it doesn't matter.

4. Start the engine again, because under idle working conditions, further discharge the air in the cooling system to reduce the coolant level.

5. Wait for a few minutes until the coolant level no longer moves, add coolant again between the two calibration lines, and the coolant replacement is completed.

How to Remove the Spring of the Fuel Tank Switch for 2010 Honda Fengfan

Use a 10mm socket wrench to remove the two screws, and slowly turn off the buckle of the fuel tank. Remove the spring clip on the original fuel tank cover, and the spring will fall directly. Use a large tapered reamer to pry open the spring head. The switch spring mainly controls the opening and closing of the fuel tank. If it is not replaced in time, the Honda fuel tank will not be able to open and close properly.

Where and How to Open the Fuel Tank Cover of Fengfan

The fuel tank cover switch of Dongfeng Honda Fengfan is located below the driver's seat on the left side. The specific operation method is as follows:

1. First, find the opening switch of the fuel tank cover of Dongfeng Honda Fengfan, as shown in the figure below.

2. Next, pull up the switch of Dongfeng Honda Fengfan, and the fuel tank cover will pop open.

3. Then, turn counterclockwise to unscrew the inner cover of the fuel tank of Dongfeng Honda Fengfan.

4. Hang the removed inner cover of Dongfeng Honda Fengfan on the hook inside the outer cover of the fuel tank.

5. Finally, tighten the inner cover of the fuel tank of Dongfeng Honda Fengfan clockwise.

6. Finally, press the outer cover of the fuel tank of Dongfeng Honda Fengfan and fasten it to complete.

How to Open the Fuel Tank Cover of 2009 Honda Fengfan

There should be a switch next to the driver's seat and the rear door switch together, but it should be pressed downward. If it is the trunk door, it needs to be pulled upward. [If there are any car issues, ask the car master. Professional technicians from 4S stores can solve it in 10 minutes.]

If you want to know more about this information, remember to bookmark and follow this site.